To determine whether the cylinder sealing of the pneumatic actuator is good, the following methods can be used:



Appearance inspection method: directly observe the surface of the cylinder to check for obvious wear, scratches, cracks, and other damages that may cause air leakage. Special attention should be paid to the cylinder barrel, end cover, piston and other parts of the cylinder, which are key areas prone to sealing problems. If oil stains or impurities are found attached to the surface of the cylinder, and the oil stains show signs of being blown out by gas, it may be due to poor cylinder sealing causing gas leakage and carrying out internal lubricating oil.


Pressure test method: use professional Pressure test equipment to fill the cylinder with gas of a certain Pressure. Usually, the Pressure filled should reach the working Pressure of the cylinder or even slightly higher than the working Pressure, and then observe the change of Pressure. The Pressure sensor and data acquisition equipment can be used to accurately measure the drop value of Pressure in the cylinder for a period of time. If the Pressure drops significantly beyond the normal range, it indicates that the cylinder has a sealing problem. After pressurization, soap water or specialized leak detectors can also be applied to the sealing parts of the cylinder, such as the connection between the cylinder head and cylinder barrel, the fit between the piston and cylinder barrel, and the inlet and outlet ports. If bubbles are generated, it indicates that there is air leakage in that area.


Action testing method: Observe the smoothness and speed of the action of the pneumatic actuator under normal or simulated working conditions. If the cylinder appears obvious jamming, shaking or uneven speed during extension and retraction, it may be due to poor internal sealing of the cylinder, resulting in gas leakage and unstable Pressure on both sides of the piston. It is also possible to compare the operating time of this cylinder with other normal cylinders under the same working conditions. If the extension or retraction time of a cylinder significantly increases, it may be due to poor sealing, resulting in gas leakage and affecting the movement speed of the piston.


Disassembly inspection method: When there is suspicion of poor cylinder sealing and other methods are difficult to accurately determine, the cylinder can be disassembled. Check the sealing ring on the piston for wear, deformation, aging, or damage. The sealing ring is a key component to ensure the sealing performance of the cylinder. If there are cracks, gaps, or loss of elasticity on its surface, it will cause sealing failure. At the same time, check whether there are signs of wear and tear on the inner wall of the cylinder. If the inner wall surface is not smooth and there are longitudinal or transverse scratches, it will affect the fitting accuracy between the piston and the cylinder wall, leading to gas leakage. In addition, it is necessary to check whether the sealing gasket at the cylinder end cover is intact, whether there is damage or deformation, and whether the connecting bolts are loose, which may also affect the sealing performance of the cylinder.